eXtended Video System Version 3 B
New Version 2020
XVID3B is a professional analog video system prepared for all types of applications FPV to work between 25-40Km (LOS) with antennas included in the kit, or 100km with high gain parabolic antennas.
RXVID3-1G2. Analog diversity video receiver 1.2Ghz and short range transmitter 5.8Ghz:
Analog video receiver with two internal modules simultaneous video receivers with 8 video channels and battery with autonomy of 8-10h approximately.
Frequencie band: Receiver of 1.2Ghz and also has a 5.8Ghz short range video transmitter to view the video in wireless mode with one or more video glasses or video FPV monitors with 5.8Ghz receiver, you can get ranges of 50-100m or more depending on the antenna.
Diversity mode: RXVID3-1G2 has two antenna inputs and internally selects the best video signal reception from the two receiver modules. You can install in the receiver (No.1) a directional antenna for long range and in receiver (No.2) an omnidirectional antenna for nearby flights, in this way you will get a good combination of antennas and good video signal for short and long range.
XOSD3B-1G2. OSD with analog video transmitter 1.2Ghz of 1W:
Video transmitter with 8 video channels and inputs for 2 video cameras with PAL format.
Frequencie band: 1.2Ghz.
Power RF: 1W (+30dBm).
OSD presents graphics, icons and W/B texts on the screen, superimposing the objects on the analog video. It is mainly oriented for the visualization of the instruments of an aircraft and flight data on planes, helicopters and radio control systems FPV, Unmanned Aerieal Vehicle UAV , robots, vigilance, etc.
Displaying the data of the XLRS radio link and the instruments using the Mavlink telemetry of the autopilot, flight data, alarms, battery status, video channel, selected camera, OSD brightness, etc. Configurable objects through DMDStudio software.
Interprets Mavlink data packets of Pixhawk autopilot or autopilots compatibles with Mavlink protocol.
- To work from (LOS): 25-40km.
- Range maximum (LOS): 100km.
More information about XVID3B on www.xlrs.eu.
XLRS diagrams connected.
DMDStudio, software configuration XLRS system.
1- RXVID3-1G2 (1.2Ghz). Analog video receiver 1.2Ghz and video transmitter 5.8Ghz.
1- XVID3B-1G2 (1.2Ghz). OSD with analog video transmitter 1.2Ghz 1W.
1- DCDC38/5RC. DCDC Adjustable step down module, INP 4-38V, OUT 1.25-32V(Adjustable), Out current 5A.
2- ANTGSM12. Omnidirectionals antennas 1.2Ghz 5dBi.
1- BQ12. Biquad Antenna 1.2Ghz 9dBi.
1- ANTGSM58. Omnidirectional antenna 5.8Ghz 5dBi.
1- LAT05M_SMAH/SMAM. Cable SMA-Female to SMA-Male, 500mm.
1- LAT20MSMAFNM. Cable SMA-Male to Connector N-male, 200mm.
1- LAT15_SMAH/MMCXM. Cable SMA-Female to MMCX-Male, 150mm.
1- CABLE_PX4_XOSD. Cable Pixhawk for XOSD.
1- CABLE_SERVO_HH. Cable Servo RC Female to Female.
1- CABLE_USB/MICROUSB. Cable USB-A Male to Micro USB-B Male, 2m.
1- CABLE_JRCA. Cable Audio Stereo MiniJack 3.5M to RCA Male.
* The image information shown on this page, are only referential and may differ from the final product.
* The ranges shown are estimates and in optimal conditions.
* Note: Analog video systems with powers greater than 25mW or 100mW at 2.4Ghz shouldn’t be used in Europe, except authorized users. An RF attenuator can be included in the output of the video transmitter to comply the standards of each country.